“02_2.led” - NO.3 program for No.2 controller.

“01_2.led” - NO.2 program for No.2 controller.

“00_2.led” - NO.1 program for No.2 controller.

“15_1.led” - NO.16 program for No.1 controller.“02_1.led” - NO.3 program for No.1 controller.“01_1.led” - NO.2 program for No.1 controller.“00_1.led” - NO.1 program for No.1 controller.Name of the program(The rule of how to name the programs) The name for NO.2 controller

When you need to built a new project the controller type for the software is：T-1000-IC model. If you need to use RS485 signal you need to connect controller A with LED A (DMX+), controller B with LED B(DMX-), If the chip for LED is double line chip with DAT and CLK, then need to be connected with DAT, CLK, and GND of the controller. When the chip for LED is single line chip just with data, then just need to be connected with DAT and GND of the controller. T-1000S one TTL(SPI) signal and one RS485 signal port output，can control 2048 pixels； Multiple T-1000S controllers can be cascaded together and work synchronous. NOTE：For the TTL(SPI) signal, the controller signal ground must connect to the LED ground directly. TM1804 and TM1809 are divided into high and low T-1000S must use the new software LedEdit 2012. When T-1000S control more than 512 pixels the frame rate will slow down automatically. When T-1000S controller less than 512 pixels the frame rate can reach 30fps.

7、Compatible with single line or double line chips.

6、The program must be named in orders.

5、T-1000S store a maximum of 16 programs，copy multiple files to the SD card in order, after formatting the SD card as “FAT” format.

4、Off-line(SD Card) control, play back content stored in the SD card.

3、Single-port output，can support 2048 lights。.

2、Support the rules and special-shaped handle.

1、32-256 Gray，Support software Gamma correction。.

Sd card controller ic